NSW SES Profile V1

RFS, SES, SLSA, VRA, SJA
centralcoastscanman
Posts: 750
Joined: Fri Oct 31, 2008 7:58 pm
Contact:

Re: NSW SES Profile V1

Post by centralcoastscanman » Sun Jun 08, 2014 9:35 am

Bigfella237 wrote:
Mr Flibble wrote:Zone 2 in the SES radios is an Empty Zone therefore I didn't feel the need to post it. ~ Don't know what the SES tech creating that profile was thinking ~
From memory I believe Zone 2 has ACTSES talkgroups for liaison, but only in Southern Highlands' radios?

Andrew
I can confirm Zone2 is a blank zone in Southern Highlands Radio's, the ACTSES TG's are in Zone4(i think)

Keeping in mind i have not seen the new radio profile so this could change again

ivahri
Posts: 843
Joined: Sun May 31, 2009 8:24 pm

Re: NSW SES Profile V1

Post by ivahri » Sun Jun 08, 2014 11:19 am

Mr Flibble wrote:
Garry wrote:also, just to avoid any confusion, the zones about are in the radio as follows

listed above as zone 1 is zone 1
listed above as zone 2 is zone 3
listed above as zone 3 is zone 4
listed above as zone 4 is zone 5
Zone 2 in the SES radios is an Empty Zone therefore I didn't feel the need to post it.

Don't know what the SES tech creating that profile was thinking but I shouldn't be surprised. The RFS techs rolled out a codeplug to most of the state that had no transmit frequency programmed for a whole bunch of PMR channels... :roll: :? :oops:
If you wrote radio profiles you might realise that sometimes you have to put dummy channels in where the spectrum hasn't been licensed yet but you still want the radio users to become accustomed to the appearance before you start implementing the networks. There are dummy channels in my agency's profile and it is deliberate... no need for eye rolling and no "oops" either!

Richard

User avatar
cartman
Posts: 2179
Joined: Wed Aug 13, 2008 12:54 pm
Location: Liverpool, NSW, Australia

Re: NSW SES Profile V1

Post by cartman » Thu Dec 25, 2014 11:04 am

There must a newer SES P25 regional profile in the process of being implemented across the state .... stumbled across a few in the Forster region (with a common regional input) with a 30/6/14 inital licence date, obviously replacing the analog, with 10K1F9W P25 voting. Unknown NAC

1802043 421.8875 Tx Bulahdelah
1802044 423.7875 Tx Nerong
1802045 421.7750 Tx Peppers Mt
1802046 421.9625 Tx Smiths Lake
1802047 420.2500 Tx Coolongook

On the ACMA it is being shown as NSW Telco (SES Acct)
Worth investigating as to what has been licenced in the last six months ... I have just managed to look up these before i go off to Xmas lunch then work tonight

Grant
Professional Scanner nut. Ibis bin chicken of radio scraps
Scanners:
Uniden 325P2, Whistler TRX-1, GRE PSR800 x 2, Uniden 780 x 3, Uniden 796, Uniden 396 x 2, Uniden 246,
Software:
DSD v2.368, Unitrunker, Trunkview

User avatar
Garry
Posts: 613
Joined: Sun Aug 17, 2008 7:09 pm
Location: Newcastle
Contact:

Re: NSW SES Profile V1

Post by Garry » Thu Dec 25, 2014 12:13 pm

:)
Happily Scanning Since 1983

Wonky
Posts: 302
Joined: Thu Aug 14, 2008 6:08 pm

Re: NSW SES Profile V1

Post by Wonky » Thu Dec 25, 2014 11:28 pm

A few in the sth west too:
Input of 429.1750 for
Tarcutta 421.7625
Ardlethan 421.8750
Cootamundra 421.8500
Lockhart 421.9000
Coolamon 421.9500
Wagga North 423.9750
Urana 421.7875
The Rock 421.8625

Input of 429.1500:
Griffith 421.8125
Gundaline 421.9500
Darlington Pt 423.9500
Narrandera 421.9375

Input of 427.0875:
Rankin Springs 421.8875
Maude 423.9000
Hay 423.0875
Hay 421.7625
Monia Gap 421.8250
Galah 423.7875

User avatar
cartman
Posts: 2179
Joined: Wed Aug 13, 2008 12:54 pm
Location: Liverpool, NSW, Australia

Re: NSW SES Profile V1

Post by cartman » Mon Dec 29, 2014 4:10 am

Input 427.0000Mhz
1802037 421.8000 Tx Mt Marie, Taree
1802036 421.8500 Tx Middle Brother
1802038 421.9250 Tx Mt Ganghat
1802039 423.7625 Tx Mt Talawahl, Nabiac

Input 427.0125Mhz
1801985 421.8125 Tx Albury
1801990 421.8875 Tx Jingellic
1801986 421.9125 Tx Goombargana Hill via Walbundrie
1801988 421.9625 Tx Berrigan
1801989 423.9000 Tx Mt Raven

Input 427.0625Mhz
1802000 421.7750 Tx Conargo
1801999 421.8000 Tx Wanganella
1801995 421.8125 Tx Barham
1802001 421.8250 Tx Jerilderie
1801994 421.8625 Tx Deniliquin
1802002 421.8625 Tx Maude (Lowbidgee)
1801993 421.8875 Tx Moama
1801992 421.9000 Tx Mathoura
1801991 421.9375 Tx Finley
1801998 423.8250 Tx Moulamein
1801996 423.8375 Tx Tooleybuc

Input 427.0875Mhz
1802015 421.7625 Tx Hay
1802019 421.8250 Tx Mt Bootheragandra (Monia Gap)
1802018 421.8875 Tx Rankin Spring
1802020 423.7875 Tx Galah
1802016 423.8375 Tx Hay
1802017 423.9000 Tx Maude

Input 427.1625Mhz
1802043 421.8875 Tx Bulahdelah
1802044 423.7875 Tx Nerong
1802045 421.7750 Tx Peppers Mt
1802046 421.9625 Tx Smiths Lake
1802047 420.2500 Tx Coolongook

Input 429.0375Mhz
1802041 421.8250 Tx Mt Berrico, Gloucester
1802042 421.9375 Tx Mt Myra
1802040 423.8375 Tx Copeland Tops

Input 429.0875Mhz
1802027 421.7875 Tx Mt Burra, Gundagai
1802024 421.8000 Tx Tumbarumba
1802022 421.9625 Tx Tumorrama Mt, Tumorrama
1802021 423.7750 Tx Tumut
1802026 423.8125 Tx Gundagai
1802029 423.8875 Tx Big Talbingo Mt
1802023 423.9375 Tx Batlow
1802028 423.9500 Tx Mt Yaven

Input 429.1500Mhz
1802031 421.8375 Tx Comboyne West
1802035 421.8625 Tx Mt Yarrahapanni
1802032 421.9000 Tx Jolly Nose Hill
1802033 421.9750 Tx Mt Cairncross
1802034 423.9375 Tx Yarras
1802030 423.9500 Tx Kempsey

Input 429.1500Mhz
1802011 421.8125 Tx Griffith
1802013 421.9375 Tx Square Head, Narrendera
1802014 421.9500 Tx Gundaline
1802012 423.9500 Tx Darlington Point

Input 429.1750Mhz
1802004 421.7625 Tarcutta (Mt Burngoogee)
1802008 421.7875 Urana
1802007 421.8500 Cootamundra (Mt Ulandra)
1802009 421.8625 The Rock (Bulloc Bulloc Hill)
1802005 421.8750 Ardlethan (Mt Beckham)
1802003 421.9000 Lockhart (Galore Hill)
1802006 421.9500 Coolamon
1802010 423.9750 Wagga North (Malebo Hill)

5w Ambulatory
1977271 415.4500 NSW Wide. Simplex
1977272 422.6125 NSW Wide. Simplex
1977273 426.0125 NSW Wide. Simplex
1977274 426.2750 NSW Wide. Simplex
Professional Scanner nut. Ibis bin chicken of radio scraps
Scanners:
Uniden 325P2, Whistler TRX-1, GRE PSR800 x 2, Uniden 780 x 3, Uniden 796, Uniden 396 x 2, Uniden 246,
Software:
DSD v2.368, Unitrunker, Trunkview

User avatar
tsunami_australia
Posts: 108
Joined: Thu Dec 03, 2015 12:20 pm
Location: Mid North Coast NSW Australia

Re: NSW SES Profile V1

Post by tsunami_australia » Sun Dec 10, 2017 7:51 pm

Interesting to see these lists and from so long ago yet SES are *STILL* on the analogue channels as well around Taree. Would be curious to know why it's taking them so long to change over (longer than the RFS).

Air490
Posts: 62
Joined: Fri Aug 22, 2008 8:18 pm
Location: Port Macquarie

Re: NSW SES Profile V1

Post by Air490 » Sun Apr 15, 2018 1:22 pm

Doing a bit of re-programming this morning. SES in Albury are now on P25. They were doing some radio testing and made reference to using the "new" radios.

User avatar
Garry
Posts: 613
Joined: Sun Aug 17, 2008 7:09 pm
Location: Newcastle
Contact:

Re: NSW SES Profile V1

Post by Garry » Sun Apr 15, 2018 2:05 pm

cool !!
Happily Scanning Since 1983

Farsouthscanner
Posts: 431
Joined: Thu Sep 04, 2008 10:47 pm
Location: Far South Coast NSW

Re: NSW SES Profile V1

Post by Farsouthscanner » Sat Apr 17, 2021 5:49 pm

It appears the SES profile has been changed.
Eden SES are using TG 20262 for a rescue job down near the Vic border.
It's interesting as up until now talk groups down this way started with a 3

Post Reply