scanSydney

For TRX owners - i was wondering is it possible for the TRX-1 to be programmed to show dmr/nxdn signal data for a frequency range when there is no voice present. I have noticed that the TRX-1 skips over the dmr/nxdn data channels/pulses in search mode. I am hoping that i may have a setting in the wrong mode. Having the TRX-1 do that would be helpful in searching for new signals

I am used to the Dsd software + discriminator tap which shows channel data and decodes voice if present

Hi Grant,

I haven't been able to get mine to do that, only stops on DMR when voice signal detected. Be interested to hear other owners experience.

Regards
Kev

BUILT-IN DISCRIMINATOR OUTPUT - provides raw discriminator signal to third party signal decoding software w/o risky hardware modifications

Saw this on the radioreference TRX-1 wiki
Might be able to run DSD alongside?

Update: i think so via earpiece audio jack.
For those who like to look inside:
https://forums.radioreference.com/whist ... nator.html

You can via the Headphone jack, you can select it via the Radio or program it via the EzScan software. Can IF out via the Headphone jack, I have used it with DSD, Unitrunker and other applications fine! Just remember to find the correct audio volume setting for the software.