Sydney Airport Corporation Limited (SACL)
-
- Posts: 1532
- Joined: Sat Feb 06, 2010 9:41 am
Sydney Airport Corporation Limited (SACL)
Site: Sydney Airports Corp Site International Terminal SYDNEY AIRPORT
(Confirmed)
P25 487.25000 NAC 526 [Clear]
P25 487.35000 NAC 526 [Clear] (Seems to be Main Channel - "Control")
P25 487.65000 NAC 526 [Clear] (Recorded Loop Messages - "Duress Alarm @ T1 Main Screening Point")
(To Be Confirmed)
487.0500
487.5000
487.7750
Seems to be low-power, and will only pickup within a few km's of the airport.
The above frequencies were registered on the 02-SEP-11 - theres a couple of older ones from about 2006 in the 470~ range on that site too, but i've only listed the most recent additions.
http://web.acma.gov.au/pls/radcom/site_ ... _ID=203011
(Confirmed)
P25 487.25000 NAC 526 [Clear]
P25 487.35000 NAC 526 [Clear] (Seems to be Main Channel - "Control")
P25 487.65000 NAC 526 [Clear] (Recorded Loop Messages - "Duress Alarm @ T1 Main Screening Point")
(To Be Confirmed)
487.0500
487.5000
487.7750
Seems to be low-power, and will only pickup within a few km's of the airport.
The above frequencies were registered on the 02-SEP-11 - theres a couple of older ones from about 2006 in the 470~ range on that site too, but i've only listed the most recent additions.
http://web.acma.gov.au/pls/radcom/site_ ... _ID=203011
Last edited by matthewn1983 on Mon Feb 06, 2012 9:15 pm, edited 7 times in total.
-
- Posts: 1532
- Joined: Sat Feb 06, 2010 9:41 am
Re: Sydney Airport Corporation Limited (SACL)
Yeah was clear, ill have to keep an eye out in the terminal tomorrow, wasn't aware they were P25 until a close call hit while sitting at the lights outside Arrivals.
Re: Sydney Airport Corporation Limited (SACL)
So there basically using the same frequencies but in P25 mode.
Will just need to remove the analogue subtones programmed into my digital scanner then.
John.
Will just need to remove the analogue subtones programmed into my digital scanner then.
John.
-
- Posts: 1532
- Joined: Sat Feb 06, 2010 9:41 am
Re: Sydney Airport Corporation Limited (SACL)
They had some 470mhz freq too on that site, but so far I have only heard the 1 channel in p25.
-
- Posts: 1532
- Joined: Sat Feb 06, 2010 9:41 am
Re: Sydney Airport Corporation Limited (SACL)
Updates above. Added 2 to confirm with observations.
Re: Sydney Airport Corporation Limited (SACL)
http://www.c4i.com/announcements/public-safety
dated 11.AUG.2011
C4i was engaged by Airservices Australia to provide a national Emergency Response system for twenty airports around the country. The solution utilised the inherent distributed architecture of Alarmon, allowing assets anywhere within the national system to be accessed by operators at any of the airports.
Operationally this allows an operator in Melbourne to take control and manage incidents at Sydney Airport (geographically 1000 Kilometres apart) in times of incident. This provides the Emergency Response crew with additional resources in managing incidents, as all staff in close proximity to the incident can assist with the actual task of responding. Also, the Melbourne-based operator would be presented with all the communications assets of Sydney, including direct numbers, fire panel information, and procedures specific to that airport.
In times of emergency it is a crew’s rapid response and ability to provide resources immediately that will determine the seriousness and final outcome of an incident. The national system implemented in Australia uses technology to maximise use of resources already available at other airports and to minimize response times during crisis management.
dated 11.AUG.2011
C4i was engaged by Airservices Australia to provide a national Emergency Response system for twenty airports around the country. The solution utilised the inherent distributed architecture of Alarmon, allowing assets anywhere within the national system to be accessed by operators at any of the airports.
Operationally this allows an operator in Melbourne to take control and manage incidents at Sydney Airport (geographically 1000 Kilometres apart) in times of incident. This provides the Emergency Response crew with additional resources in managing incidents, as all staff in close proximity to the incident can assist with the actual task of responding. Also, the Melbourne-based operator would be presented with all the communications assets of Sydney, including direct numbers, fire panel information, and procedures specific to that airport.
In times of emergency it is a crew’s rapid response and ability to provide resources immediately that will determine the seriousness and final outcome of an incident. The national system implemented in Australia uses technology to maximise use of resources already available at other airports and to minimize response times during crisis management.
Re: Sydney Airport Corporation Limited (SACL)
The cleaners in Terminal 3 (ie Virgin Terminal) this morning are still using GP328 radios
Grant
Grant
Professional Scanner nut. Ibis bin chicken of radio scraps
Scanners:
Uniden 325P2, Whistler TRX-1, GRE PSR800 x 2, Uniden 780 x 3, Uniden 796, Uniden 396 x 2, Uniden 246,
Software:
DSD v2.368, Unitrunker, Trunkview
Scanners:
Uniden 325P2, Whistler TRX-1, GRE PSR800 x 2, Uniden 780 x 3, Uniden 796, Uniden 396 x 2, Uniden 246,
Software:
DSD v2.368, Unitrunker, Trunkview
Re: Sydney Airport Corporation Limited (SACL)
Heard the recorded loop messages at 1am today on 487.6500 NAC526 in Clear Mode
Making the trip into Blacktown from Mascot
Listening on the GRE PSR800 scanner which displays NAC and Radio Ids
"Duress alarm activated at T1 Main screen point" .... Radio Id logged
"Duress alarm activated at T1 PB Transit Screening Points on arrival" .... Radio Id logged
"Duress alarm activated at T1 PC Staff and Goods Entry" .... Radio Id logged
"Duress alarm activated at T1 PC Transit Screening Points on arrival" .... Radio Id logged
They must test the duress alarms after "closing" for the night
Grant
Making the trip into Blacktown from Mascot
Listening on the GRE PSR800 scanner which displays NAC and Radio Ids
"Duress alarm activated at T1 Main screen point" .... Radio Id logged
"Duress alarm activated at T1 PB Transit Screening Points on arrival" .... Radio Id logged
"Duress alarm activated at T1 PC Staff and Goods Entry" .... Radio Id logged
"Duress alarm activated at T1 PC Transit Screening Points on arrival" .... Radio Id logged
They must test the duress alarms after "closing" for the night
Grant
Professional Scanner nut. Ibis bin chicken of radio scraps
Scanners:
Uniden 325P2, Whistler TRX-1, GRE PSR800 x 2, Uniden 780 x 3, Uniden 796, Uniden 396 x 2, Uniden 246,
Software:
DSD v2.368, Unitrunker, Trunkview
Scanners:
Uniden 325P2, Whistler TRX-1, GRE PSR800 x 2, Uniden 780 x 3, Uniden 796, Uniden 396 x 2, Uniden 246,
Software:
DSD v2.368, Unitrunker, Trunkview