ARC96 settings for NSW GRN

Post Reply
crafty
Posts: 65
Joined: Wed Aug 20, 2008 9:56 pm
Location: Coffs Harbour

ARC96 settings for NSW GRN

Post by crafty » Fri Oct 05, 2018 11:17 am

Hi everyone
Can I confirm if these settings are correct for the NSW GRN
ARC96_NSW_GRN_Settings.jpg
(104.59 KiB) Not downloaded yet
Lo Chan | Hi Chan | Offset | Base | Step
16384 | 20479 | 16384 | 412.4750 | 06.25

I've worked out there is 14 proposed North Coast GRN sites I should be able to receive from my home near Coffs Harbour.
I am planning to program my old 2096 and DTS96 as the frequencies appear on the ACMA database.
Some of the posts on this site are few years old now, and not sure if these settings are still correct.

Regards Allison

Mike Alpha
Posts: 672
Joined: Thu Aug 14, 2008 8:22 pm

Re: ARC96 settings for NSW GRN

Post by Mike Alpha » Fri Oct 05, 2018 11:53 am

This previous post has the right settings http://www.scansydney.com/board/viewtop ... +96#p15812
Will allow tracking of sites in the 420MHz band.

Mike

crafty
Posts: 65
Joined: Wed Aug 20, 2008 9:56 pm
Location: Coffs Harbour

Re: ARC96 settings for NSW GRN

Post by crafty » Fri Oct 05, 2018 5:24 pm

Mike Alpha wrote:This previous post has the right settings http://www.scansydney.com/board/viewtop ... +96#p15812
Will allow tracking of sites in the 420MHz band.

Mike
thanks Mike

Post Reply