Delegation function on Unitrunker and GRN

Wonky · Post by **Wonky** » Tue Jan 13, 2009 9:14 pm

Hi everyone,
I have finally made it to Sydney with my laptop and disc. tapped scanners for Unitrunker. From where I am in the Homebush area, I am getting great reception from numerous sites and unitrunker is decoding fine, not even a single crash. However I am having trouble getting the delegate function setup and working for the different zones. Has anyone got it working? Here is how I have set it up as per the instructions from Rick in this RR thread http://www.radioreference.com/forums/sh ... 15&page=11

In my XML file I have changed the delegate system ID to 3A0D for both zone 2 and 3 as below. I save the changes then exit the XML file and run unitrunker again. The zone 2 site does not recognise the RIDS and TG’S I have saved for zone 1. I am using notepad to open the XML file and make the changes. If I then open the XML file again, the delegate as changed back to “0”

I have tried to use XML editor to change the XML file, but it does not seem to allow me to edit the data.
Any suggestions greatly appreciated!

<System id="5D0D" type="Motorola" label="NSW GRN Z2" first="20080731020750" last="20090113094235" delegate="3A0D"
<System id="7D3D" type="Motorola" label="NSW GRN Z3" first="20080730113320" last="20090113080020" delegate="3A0D"

Thanks,

Wonky