GME Telemetry Radio Software

Post Reply
MarkSR
Posts: 1
Joined: Sun Sep 22, 2013 8:36 pm

GME Telemetry Radio Software

Post by MarkSR » Thu Nov 16, 2017 11:19 am

Looking for GME Telemetry radio dealer software (Australia NZ) for TX3600-TX3800. I have a UHF CB repeater that uses 2 x TX3600T. The TX radio OP device has failed and I want to either swap the RX/TX radios around or convert a spare TX3800 PMR radio to a telemetry version as the repeater TX radio. Both TX and RX radios are connected to a RP3800 interconnect board. I understand I actually need to "flash" new firmware into the TX3800 using a different cable (9 PIN D to 10 pin header inside radio) to make it work as a telemetry radio. Of course with my existing software I can configure the TX3800 to accept control from the TX3600 RX radio, but I'd rather just swap around the failed radio and that's why I need the Telemetry Software to reconfigure them. Cheers.

Sent from my SM-G900I using Tapatalk

User avatar
Bigfella237
Posts: 1895
Joined: Fri Feb 26, 2010 3:11 pm
Location: In geosynchronous orbit above the Far South Coast of NSW, Australia

Re: GME Telemetry Radio Software

Post by Bigfella237 » Thu Nov 16, 2017 2:12 pm

I have no idea what this software is as I've never used it, but this is the only software I have for those radios:

http://www.mediafire.com/file/3trqmo8cs ... tx3800.zip

Zipped file details:
3608691 bytes
MD5: 467b3a6558a91e67fc10c8969612202d
SHA1: 205ce35cb69c07d1630a9e8d6439b50adacaa353

Hope it helps!
Andrew

Post Reply