Scanner for decoding

POCSAG, Mobitex

Re: Scanner for decoding

Postby soupbones » Wed Nov 12, 2008 5:48 am

scanSydney wrote:This site tends to be a bit vague with it's instructions. On this page:
http://www.discriminator.nl/ubc120xlt/index-en.html

Is it basically saying, I need to solder a piece of wire from 'pin 9' to a 3.5mm thing?



3.5mm thing would be a 3.5mm audio socket. Same type on millions of audio players where you plug headphones in. Only a mono one of course, not stereo.
Adding a discriminator to a hand held scanner can be tricky, specially when it comes to soldering the wires to the leg of a chip. On base units its a lot easier as the discriminator much of the time has a simple pointon the circuit board where you can easily solder.
Many of the Uniden base models even have it written on the boards where the discriminator is.
soupbones
 
Posts: 455
Joined: Wed Aug 13, 2008 10:23 pm

Re: Scanner for decoding

Postby vk2fear » Sun Jul 12, 2009 8:59 pm

Hi all dose anyone have the cap code for 421 PICTON

Thanks Nathan
Call sign:VK2FEAR
SCANNING WITH:
FT8800 x2 - FT60 - UBC245XLT - UBC120 - UBC72XLT - UBC780xlt - UBCD396T -
UBCD996T x2 - TX-3800 x2 - T-2020 66/88mhz X 4 - T-2010 66/88mhz x4 - TS-480 sat
vk2fear
 
Posts: 126
Joined: Sun Aug 24, 2008 5:25 pm

Previous

Return to Paging/Data

Who is online

Users browsing this forum: No registered users and 1 guest

cron

x